User manual

Chapter 3 Installation
3-12 ADVANCED MICRO CONTROLS INC
IMT Transducer Interface Module
The IMT is an interface module that simplifies field wiring to a 1733, 1734, 1743 or 1744.
This module has terminal blocks that connect four C1T transducer cables to a single eight foot
cable. This cable connects the IMT to the module. Figure 3.19 is an outline drawing of the IMT
and cable. The C1T cable wiring diagram is figure 3.15, on page 3-9.
GRN BLK WHT BLK BLU SHIELDS YEL BLK BRN BLK BLK SHIELDS RED BLK
87654321 91011121314
876
5
4
3
21
9 1011121314
5.00"
(127.0)
4.500"
(114.30)
3.00"
(76.2)
2.500"
(63.50)
0.25"
(6.4)
0.25"
(6.4)
0.17"
(4.3)
Dia. Thruhole (Four places)
IMT INTERFACE MODULE
0.44"
(11.2)
1.40" max.
(35.6)
1.80"
(45.7)
max. with mating connectors installed.
(Transducer 4 connector shown.)
Additional 1"
(25)
clearance recommended
for mating connector removal.
TRANSDUCER 2 TRANSDUCER 4
TRANSDUCER 1 TRANSDUCER 3
Module Connector
AMCI Part #: MS-14
Phoenix Part #:
MSTB2.5/14-ST-5.08
17 57 13 2
(Four places)
C4IMT Cable
Pre-assemblied 8 ft. cable
with connectors. The cable
is included with the IMT
module. Ends of the cable
are interchangable.
BELDEN 9731
Figure 3.19 IMT Outline Drawing