Installation manual

Step 2.4 Press the key.
The display indicates the second
Factory parameter.
Step 2.5 Press the ENT key.
The display shows that 37 KW
(65 Amps.) unit for 460 V is
selected. If the display does not
match the actual unit rating,
first set the password (F.000),
and then set again the Unit
Selection conforming to the unit
rating (refer to the section
"Factory Parameters" in Chapter
7).
Step 2.6 Press the PRG key.
The display indicates the second
Factory parameter (F.001).
Step 2.7 Press the PRG key.
The display shows "F.---"
indicating that you can access
the Factory parameters.
Step 2.8 Press the PRG key.
The operation panel returns to
monitor mode again. The
display indicates the input
current and the "A" status LED
turns ON. This display shows
the input current is 0 Amp.
Start and Adjustment
5-5
RST
PRG
ENT
READY
READY
FAULT
FAULT
PROGRAM
PROGRAM
kW
kW
V
A
RST
PRG
ENT
READY
READY
FAULT
FAULT
PROGRAM
PROGRAM
kW
kW
V
A
RST
PRG
ENT
READY
READY
FAULT
FAULT
PROGRAM
PROGRAM
kW
kW
V
A
RST
PRG
ENT
READY
FAULT
PROGRAM kW
V
A
RST
PRG
ENT
READY
READY
FAULT
FAULT
PROGRAM
PROGRAM
kW
kW
V
A