User manual

33 Publication 1734-UM015A-EN-E - November 2009

Chapter

DeviceLogix for POINT I/O and ArmorPOINT

I/O on DeviceNet

About This Chapter

This chapter provides information on the following:

• Offline Configuration using RSNetworx for DeviceNet

• Online Configuration using RSNetWorx for DeviceNet

• I/O Data Assembly Maps

Offline Configuration using

RSNetworx for DeviceNet

This section is not a substitute for RSNetworx or DeviceNet scanner and

adapter publications. It is suggested that you have those publications available

while performing the procedures in this section See Related Publications

for a

list of related publications.

This section describes the setup of a DeviceNet network using RSNetworx for

DeviceNet when the module is not connected to the network.

When configuring the module in the Offline mode, you must place all nodes

on the network in the View window manually. Use the Hardware tree to find

each module and place it into the View window. This can be done by

double-clicking the module or dragging it to the View window.

If using a POINT I/O or ArmorPOINT I/O DeviceNet adapter, make sure

you select Adapter for the main DeviceNet network, and Scanner for the

Pointbus backplane.