User manual

Publication 1768-UM001C-EN-P - November 2007
20 Directly Connect to a Controller Via the Serial Port
Set the IP Address via a
Serial Port
To set the IP address via a serial port, perform this procedure.
1. Make sure the module is installed, started, and connected to the
controller via a serial connection.
2. In the Controller Organizer of RSLogix 5000 programming software,
right-click the module and choose Properties.
The Module Properties dialog appears.
3. Click the Port Configuration tab.
4. In the IP Address box, type the IP address.
5. In the other boxes, type the other network parameters, if needed.
6. Click Apply.
7. Click OK.
IMPORTANT
The boxes that appear vary from one module to
another.