User manual

Publication 1768-UM001C-EN-P - November 2007
18 Directly Connect to a Controller Via the Serial Port
The Configure RS-232 DF1 Devices dialog appears.
5. From the Comm Port pull-down menu, choose the serial port on the
workstation to which the cable is connected.
6. From the Device pull-down menu, choose Logix 5550/CompactLogix.
7. Click Auto-Configure.
8. Verify that the auto configuration was successful.
9. In the Configure Drivers dialog, click Close.
If Then
Yes Click OK.
No Return to step 5 and verify that you selected the correct
communication port.