Manual

Qu Mixer User Guide 49 AP9372 iss.1
8.14 Output Patch Setup – USB Audio
This screen presents the patching of the USB audio
outputs. This includes the Qu-Drive Stereo, Qu-Drive
Multitrack and the USB B audio streaming.
These outputs share the same block of 32 patchable
tracks:
 Qu-Drive Stereo = Track 17-18
 Qu-Drive Multitrack = Track 1-18
 USB B Streaming = Track 1-32
There are two screens:
 Track 1-18 = All tracks associated with Qu-Drive
 Track 19-32 = The rest of the tracks for USB B
Touch the lower left ’19-32’ or ‘1-18’ buttons to
navigate between the screens
Touch a button and then turn the screen Rotary to
scroll through the available outputs.
Use the Fn key ‘+1’ function to quickly assign strips in
sequence.
Once you have chosen the outputs press Apply to
accept or Cancel to discard the changes.
Input sources are pre-fader. Channels are sourced
from their Insert send point. This is after the Preamp
and before the processing. This is preferred for live
multitrack recording.
Output sources are post processing, post fader.
The USB Audio factory reset default patching is:
 1-16 = CH1-16
 17-18 = LR post fader
 19-24 = ST1-3
 25-32 = CH17-24 (Not Qu-16)
8.15 Utility - Calibration
Use the routines here to calibrate the touch accuracy
of the Touch Screen and positional accuracy of the
Motor Faders.
Follow the on-screen instructions.
The following sources can be patched:
X Unassigned
CH Mono channel pre processing
ST Stereo channel pre processing
FX Ret FX returns 1-4 pre-fader
Grp Group post-fader (not Qu-16)
Mix Mix 1-10 post-fader
LR pre Main LR mix – pre-fader
LR post Main LR mix – post-fader
L+R pre Main LR mono sum – pre-fader
MTX Matrix post-fader (not Qu-16)
PAFL Stereo PAFL monitor