Owner`s manual
82
BATH SINK, SHOWER & ACCESSORIES
WATER PUMP
e motorhome is equipped
with a berglass shower sur-
round. When cleaning this
surface, use care to prevent
scratching or marring it.
e single-handled faucet in
the bathroom was chosen to
match the specied decor. e
bathing facilities installed may
be a berglass shower (Figure
13-4) or combination shower/
tub with a glass shower door.
e tub faucet with showerhead, hose, and bracket are coordinated
with the sink faucet.
e water pump is self-priming and totally automatic,
operating on demand whenever water is required. e
water pump is used to pressurize the freshwater sys-
tem when the unit is not connected to city water. e
switches (Figure 13-5) to this pump may be located in
the bathroom, galley, or sanitation-service compart-
ment. To start the pump, follow these instructions:
1. Fill or partially ll the fresh water supply tank.
2. Open the kitchen and bathroom faucets.
3. Turn the water pump switch “on” and allow the
water to ll the water line and the hot water heater.
4. Close each faucet aer it delivers a steady stream
of water (close the cold-water faucet rst). Leave the
hot-water faucets “on” until they also deliver a steady stream of water. is procedure will assure that
the water heater is lled with water.
5. e water pump should stop running once all faucets are closed.
6. e water pump is now ready for automatic operation. e pump will run when a faucet is
open and stop when a faucet is closed.
Figure 13-3:
Bathroom sink
Figure 13-5:
Water pump switch
Figure 13-4:
Shower
PLUMBING & BATH FEATURES