Owner`s manual

24
SAFETY
TOWING HITCH
e Allegro Breeze is fully capable of towing typical motor vehicles
e motorhome is equipped with a Class 2; 5,000-pound towing hitch (Figure 2-10) and associated
wiring connector.
e wiring connector features a 7-pin connector. e tongue weight is not to exceed 10 percent of the
towing capacity. If it is desired to connect a trailer brake actuator, the plug for the actuator is located to
the le of the steering column under the dash.
e motorhome is capable of towing light loads and instructions are found in the chassis-manufactur-
er’s literature in the Owner’s Information Package provided with the Allegro Breeze.
e total weight of the motorhome and any vehicle towed by that motorhome must not exceed the
Gross Combined Weight Rating (GCWR). When the motorhome is being weighed, remember to ac-
count for passengers and their locations in the motorhome.
Any vehicles to be towed by the motorhome should have adequate active braking. e wiring connec-
tor provided is a standard seven-pin connector.
Tin Motorhomes does not recommend using any type of hydraulic towing li that attaches to the
rear of the motorhome designed to carry motorcycles, scooters, golf carts, etc.
Figure 2-11: Towing hitch
Chapter 11), as needed. Connect the waste drain hose to the external sewer hook-up. Start the refriger-
ator, water heater, and furnace; as warranted. Light the oven pilot light, as needed. Certain appliances,
such as the refrigerator, will not work properly, if the motorhome is not level, so be sure to complete the
motorhome-leveling process before activating any of the appliances.