Allegro Cellular CAT-M PIT Module User Guide FCC ID: VIDCMPIT4G Contains FCC ID: N7NHL78
CAUTION This device complies with part 15 of the FCC Rules. The User and the Installer should be aware that changes and modifications to the equipment not expressly approved by Master Meter could void warranty and the user's authority to operate the equipment. Professionally trained personnel should install the equipment.
Introduction The Allegro cellular PIT Module is a battery-operated radio module designed for automated water meter reading. The Allegro cellular is capable of reading water consumption data from residential and commercial water meters equipped with an Encoder or Solid-State Register. It uses CAT-M cellular radio for relaying water consumption data to the utility.
Electrical Characteristics Battery: • Battery type: Lithium-Thionyl Chloride • Nominal voltage: 3.6 V • Capacity: 8500 mAh DC Characteristics: • Operating voltage range: 3.0 V – 3.
Functional Description The Allegro cellular PIT Module is battery endpoint for the application of automatic water meter reading. The primary function of the module is to record consumption of a water meter from an Encoder register. The count from the action of the meter advances the register and passed serially to the radio. Several operational modes are available based on production configuration, standard mode transmit daily 24-hourly meter reads.
Installation 1. Remove PIT lid, Figure 3. Figure 3 2. Pass the cable through the Lid hole and Install the PIT Module into the Pit-Set Lid, Figure 4.
3. Fasten the PIT Module to the Pit-Set Lid using the fixing nut provided, Figure 5. Figure 5 4. Connect PIT Module cable to water meter inside the Pit-Set, make sure both arrows located in front of each other and tight together, Figure 6.
5. Place magnet on PIT Module top as illustrated in Figure 7 for 20 seconds than remove the magnet. Figure 7 6. On PIT Module bottom LED will indicate (Figure 8) process as described below. 7. When magnet is sensed LED blinks 3 times. Figure 8 8. Then when magnet was removed (after 20 seconds) LED will blink several times until it finds network and connected. 9. After PIT Module was magnet activated, it will automatically be ready to transmit based on production schedule configuration.
