User's Manual

14
4.5. Retrieving the bioprinted samples
1. Please make sure the tray is in the load position before retrieving the well plate or the printing probe.
2. Open the sliding door and carefully remove the well plate from the tray. The bioprinted samples are
ready for culturing, imaging or assaying.
3. Carefully retrieve the printing probe without touching the well plate tray. Clean and store the printing
probe in a sterile container for later use.
4. Close the sliding door.
4.6. Powering off the printer
1. After the printing is finished, turn off the computer by pressing the power button in the front of the
printer.
2. Turn off the power supply of the printer by pushing the power switch on the side of the printer.
Caution: When an emergency stop is needed, push the power switch on the side of the printer directly
to shut down the printer.