User's Manual

9
4. Press the Load Position button on the Utility page and carefully load the well plate onto the tray after
it is moved to the load position.
Caution: please make sure the well plate is placed in the right orientation as shown on the Project page
and secure the well plate in the tray using the clamp.
Printing probe and well
plate used
6-well probe and 6-
well plate
12-well probe and 12-
well plate
24-well probe and 24-
well plate
Maximum volume of
bioink for each well (ml)
8.6
3.4
1.3
4.4. Setting up a bioprinting project
1. Go to the project page and press New to start a new printing project. The Project page provides an
overview of the bioprinting project and settings.
2. You can save the project using Save or Save As at this step or later.
3. You can also Open a previously saved project.
4. If heating or mixing of the bioink is needed, go to the Utility page and change the desired settings.