Installation guide
30
2.2 SERVICING THE FILTER
(Fig. 1a och 1b)
The central unit is equipped with a lter (4) that
protects the turbine against dust. The filter must
be intact and correctly in place. New lters can be
purchased from all leading retailers and authorised
Allaway service dealers.
n Unplug the power cord (5) from the socket.
n Take out the dust canister and empty it.
n Carefully remove the filter cover if any (see
section Filter Cover for the Central Unit), undo
the mounting nut (6) located underneath the lter
and remove the lter (4).
n Clean the lter by brushing it lightly, by washing
it or replace it if the lter is damaged or blocked.
Do not allow any dirt to enter the inside of the
lter.
Never clean the lter with compressed air or by beating it.
n Remove any loose dust from the lter chamber and t the lter into place. Tighten the mounting
nut (6) by hand, t the new lter cover (accessory) into place, clean the sealing / sealing cone (3)
carefully and t the sealing cone (A-series) and the dust canister into place.
n Plug the power cord (5) into the socket.
We recommend that the lter is replaced at least every 3 years. If a dust bag is used,
only replace the lter when necessary.
Tips for washinf the lter
1. Washing the Fine Filter
Always disconnect the power cord from the mains while the central unit is
missing a lter. Wash the lter under running water (max. 30ºC) or in a shower
with a gentle jet. Avoid rubbing the fine filter excessively. After washing,
check the fine filter for any damage incurred during use or washing. Never
use a damaged ne lter in the central unit. If washed incorrectly, the ne lter
may become damaged and using a damaged fine filter in the central unit can
cause a serious fault in the system. Never wash the ne lter with a pressure
washer, in a washing machine, with water in excess of 30 degrees in
temperature, using a coarse brush or with chemicals or detergents.
2. Drying the Fine Filter
The filter must be allowed to dry before it is replaced in the entral unit.
Gently shake off excess water from the ne lter after washing. Leave the ne lter
to dry at room temperature for 1-4 days, turning it over every 24 hours.
EN
Fig. 1a Fig. 1b
7
3
4
8
5
6
2
1
1
4
6
3
2
5
8
9
7