Use and Care Manual

SHELVES
(Models: WNWR42-2SSFN/WNWB-2SSFN)
 To prevent damaging the doors or gasket seals, open the doors wide when removing the shelves.
 For easier handling of bottles, it is necessary to pull the shelf out by at least 1/3. The sides of the
shelves are equipped with protective stoppers which prevent bottles from falling from the shelves.
 When removing/inserting the shelves from/into the rails, lift one side of the shelf as shown in the
picture below and pull the shelf out towards you, or push it in when inserting it, until one side is
securely seated on the rail.
(Model: WNWR28-1SSRN/WNWR55-1SSRN/WNWR53-2SSRN/WNWR142-2SSRN/WNWR150-2SS)
 To prevent damaging the door gasket, make sure to have the door all the way opened when pulling
shelves out of the rail compartment. For easy access to the bottles, you must pull the shelves
approximately 1/3 out of the rail compartment.
 To remove the shelves out of the rail, pull each shelf approximately 1/3 out. Use a long flat
screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift the
left plastic notch as shown in Figure B. Then proceed to pull out the shelf slowly.
Figure A
Figure B
Do not cover racks with aluminum foil or any other
material that will prevent adequate air circulation
within the cabinet.