Use and Care Manual

OPERATION
Functions
 Temperature Memory Function
If the power is suddenly lost, the set temperature will be saved by the unit. Once the power is back
on, the unit will be at the same set temperature.
 “Close Door” Reminder Function
When you forget to close the door or the door is not fully closed, there will be warning alarm after 5
minutes.
 Temperature Alarm Function
If the interior temperature is higher than 73 ºF (23 ºC), ’HI” is shown on the display panel and the
buzzer alarm sounds continuously after one hour. This indicates that the inner temperature is too high,
and you should look for the reason. If the inner temperature is lower than 32 ºF (0 ºC)，“LO” is shown
on the display panel; the alarm and the malfunction indicator light go on at the same time.
Note:
If too many bottles are put in at once or the door has not been closed tightly, the unit will display the “HI”
signal on the display panel. This is normal. Please wait 5 minutes after closing the door and “HI” will disappear.
 It is normal that the cabinet shows ”HI” or “LO” from time to time. If it occurs frequently or lasts for a long
time, you can restart the unit by unplugging it, then re-plugging after 5 minutes. If the problem occurs
again after restarting, please contact customer service.
 Before reconnecting the power, wait 3 to 5 minutes. You could damage your appliance if you attempt to
start the appliance earlier and it may not turn on.
 If you turn on the appliance for the first time, or after a restart, or after it has been out of operation for a
long time, there may be a temperature difference between the temperature inside the appliance and that
on the LED display. This is a normal event caused by the duration of the activation period. Leave the
appliance turned on for several hours and the temperature will stabilize during operation.