Use and Care Manual

www.allavino.com 8 1-888-980-4809
If you are going on vacation, you may leave the Wine Refrigerator operating during vacations of less than three weeks. If
the appliance will not be used for several months, you should remove all items and turn off the appliance. Clean and dry
the interior thoroughly. To prevent mold growth, leave the door open slightly, blocking it open if necessary.
Setting Temperature
This Allavino Wine Refrigerator has a wide enough temperature range to store red, white, or sparkling wine. Different
varietals of wine require different temperature settings. Red wine is generally stored between 50 and 65 degrees
Fahrenheit, while white wines are stored between 40 and 50 degrees Fahrenheit. White wine can be stored at red wine
temperatures for a short period of time (less than three months), and flash chilled before serving. The Beverage side
gets cold enough to store beer, soda or water while the Wine side is warm enough to age wine.
You can set the temperature as you desire by touching the UP or DOWN button. When you touch the buttons for the
first time, the LED readout will show the original temperature set at the manufacturing facility. Each push of the button
will adjust the temperature by one degree in the desired direction. Please be aware that the desired temperatures may
fluctuate depending on whether the interior light is ON or OFF and depending on the orientation of the bottles.
PLEASE NOTE:
In the event of a power interruption, all previous temperature settings will be automatically saved and each
compartment will return to the previous temperature setting.
If the unit is unplugged, loses power, or is turned off, you must wait 3 to 5 minutes before restarting. Attempting
to restart the Wine Refrigerator before this time has elapsed may prevent it from starting.
When you use the wine refrigerator for the first time or restart the appliance after having been shut off for a long
time, there will be a few degrees variance between the temperature you select and the one indicated on the LED
readout for the first few hours of operation. After a few hours of operation, the temperature will normalize to the
displayed temperature.
Light Settings
The Allavino Wine Refrigerator has 9 different color options and 5 different brightness levels to choose from.
Color Options: C1=Red, C2=Orange, C3=Yellow, C4=Green, C5=Cyan, C6=Blue, C7=Purple, C8=White, and C9=Rotate All
Colors
Light Brightness: b1=20%, b2=40%, b3=60%, b4=80%, and b5=100%
Factory default setting: Color: C9=All color rotation; Brightness: 40%
Light On/Off: Press the “LIGHT” button for less than 3 seconds and then release the button to turn the light on or
off. The light will turn on or off gradually. The light on/off button controls lights on both zones together.
Color Selection: Press the “LIGHT” button for more than 3 seconds, until C1 as an example is listed on the display
panel to enter the “LIGHT SELECTION” mode. Press the “UP” or “DOWN” buttons to select the color. Leave it for
10 seconds to return to normal operation.
Brightness Selection: Press the “LIGHT” button for more than 3 seconds. After C1 is shinning on the display panel,
then press “LIGHT” button again to enter into “Brightness Selection” Mode. b1 will be displayed on the panel.
Press “UP” or “DOWN” to select the Brightness.
Press “LIGHT” again to return to “Color Selection” Mode.
During either “Color Selection” or “Brightness Selection” Mode, Press “LIGHT” button for more than 3 seconds
to end the modes or leave it for 10 seconds.
The unit is programmed to remember your previous light settings in case the unit is powered off.