Install Instructions

Included in this kit:
A. Power head
B. Blue Mounting Plate
C. UVC Lamp
D. Power cord
E. Metal cutting hole sa
w
F. 3 Screws
It’s simple and fast to install!
Tools Required: Power drill and screwdiver.
A.
B.
C.
D.
E.
F.
Allanson International Inc. 33 Cranfield Rd., Toronto, ON M4B 3H2
Customer Care: 1 866 807 8049 Web: swordfishuv.com Email: [e-mail]
SWORDFISH UVC AIR PURIFICATION SYSTEM:
INSTRUCTION MANUAL
UVC AIR TREATMENT SYSTEM
Also Included: Lifetime Warranty Registration Card
CAUTION: BEFORE PROCEEDING ENSURE YOU READ THE FOLLOWING INSTRUCTIONS
CAUTION UVC/UV HAZARD: Always protect eyes from ultraviolet light. NEVER look at UV lamps in operation.
Unplug a few minutes before replacing lamp or servicing. No openings in duct are allowed which would give
direct line-of-sight to the UV light.
CAUTION PERSONAL INJURY HAZARD: Power supply can cause electrical shock. Disconnect before cleaning
or replacing ultraviolet lamps. Do not open base unit or lamp knob. There are no user-serviceable
components inside.
Serial number located here
PRE INSTALLATION:
1. Choose a location that is readily accessible for regular cleaning. Ensure there is clearance in front of Swordfish for
removing the lamp (approximately 16-18 inches) and that your duct length will accommodate the lamp size.
2. Ensure the location has a flat mounting surface and that a 120 VAC electrical outlet is within range of the unit.
3. Mount above the warm air plenum, 6 to 8 inches above your air conditioning coil. Or on the return air duct, 3 feet away
from your furnace filter or humidistat. If mounting above the air conditioning-coil ensure ample room is left above coil
so that you do not puncture refrigeration components.
CAUTION: NEVER attempt to power the unit outside of the duct. Always protect eyes from ultraviolet light.
Never look at UV lamps in operation.
CAUTION: All wiring inside the duct system in direct line of site of the UV light must be shielded with
aluminum foil or equivalent non-combustible material.
INSTALLATION:
1. Mark your location for mounting the blue mounting plate and drill a hole using the 2 inch hole saw.
2. Using screws provided affix mounting plate to duct
3. Attach the lamp to the lamp holder by steering the 4 pins into four holes. Push lamp tabs in and press the lamp in. See
Fig 1. Ensure lamp is locked into position.
4. Line up arrows on lamp holder & blue mounting house and carefully insert lamp & lamp holder into duct.
5. Once inserted, with the palm of your hand push and turn lamp holder clockwise so that it locks into place.
6. Insert power cord into lamp holder and plug other end into a 120 volt outlet. A blue LED will illuminate to show “power
on”.
Thank you for purchasing Allanson’s Swordfish UVC Air Treatment System. Swordfish uses powerful UVC technology to
purify the air your family breathes. We recommend that Swordfish be used with a good quality Allergen furnace filter to
trap sterilized contaminants for later disposal. We also recommend your furnace filter be replaced every 3 months. We hope
that you share your comments and concerns by contacting our customer care department at: 1.866.807.8049 or you can
log on to our website at www.swordfishuv.com and view our quick install video.
Part 21-686B
Rev Dec 08