Installation Guide

All Style Industries, LLC
2114 Sunset Vista Avenue Henderson, NV 89052
702-570-5520 or fax [phone]
"mailto:[e-mail]" www.spinflashing.com, or www.stormcollar.com
U.S. Patents 659156181, 664050381 and #7,770,335
Installation Instructions: Steep Slope Roofing
One Retro-Spin Flashing Kit Includes:
1. One (1) Retro-Spin® Flashing assembly with tightly fitted interior, and exterior,
impact extruded galvanized steel roof jacks.
Tools & Other Building Materials Required for Kit Installation:
1. One Hammer
2. (4) Four galvanized barbed shank roofing nails with 3/8″to 7/16″ inch diameter
flat heads.
3. Paintable Caulking for roof slopes under 3″ & 12″.
4. Spray Paint (optional)
Application of Retro-Spin:
A Retro-Spin Flashing allows installation of a new roof jack flashing around roof
penetrations that are fixed. An example is an electric service mast. These fixed
penetrations may not allow for a standard slide-on-from-the-top flashing installation.
Retro-Spin Flashing allows for a flashing installation from the side.
Apply the roofing up to the roof penetration. Notch, or cut a hole, in the roofing material
to allow the installation of the roofing product to the centerline of the roof penetration.
Do not install the roofing material further than the penetration. Use the roofing materials
manufacturer’s recommendations for installing the roof up to and around roof
penetrations.
Arrange the Retro-Spin Flashing so the interior and exterior flashings provide an open
door to the center of the flashing. The cut-out slots will be in alignment.
Please review the following installation
instructions to receive the fine quality
you expect when installing an All Style
Retro-Spin Flashing.