User manual

Zeus Series / Automated Standalone CD/DVD Duplication System / User Manual

Connecting power

Plug one power cable into the tower system, one into the autoloader and another one

into the printer. Plug each power cable into the proper power source and connect all

the other cables as shown in:

- Fig 4b or 4d or 4f for system configured with Signature Z6 printer (page 6, 7, 8)

- Fig 5b or 5d or 5f for system configured with Rimage Prism Plus printer (page 9,

10, 11 )

- Fig 6b or 6d or 6f for system configured with Pro III printer (page 12, 13, 14)

- Fig 7b or 7d or 7f for system configured with HP printer (page 15, 16, 17)

- Fig 8b or 8d or 8f for system configured with Teac P55 printer (page 18, 19, 20)

The power On/Off switch for the tower is located in the front and the one for the

autoloader is located in the back. Power the tower on first, then turn on the autoloader

and if a printer is present, turn that on last. You are now ready to align the autoloader arm

to the tower drives.