User manual

Olympus Series / Automated Standalone Asynchronous CD/DVD Duplication System / User Manual
4
Operating Environment
Your APS System should be used in a climate-controlled environment free of dirt,
dust, excess humidity, excessive heat or electro-magnetic interference. Your APS
System should be placed on a sturdy level surface – away from sources of vibration
and excessive lighting.
Allow at least four (4) inches of clearance around the sides and back of the system for
ventilation.
Connecting power
Plug one power cable into the tower system, one into the autoloader and another one
into the printer. Plug each power cable into the proper power source and connect all
the other cables as shown in fig. 3a, 3b, 3c, and 3d on the following page.
Important
Before powering on your system, please ensure the picker (see fig.1, page 3) is in the top
position.
Please power on your APS system in the following order:
1. Printer
2. Tower
3. Autoloader.
Proceed with Drive and Printer Alignment on page 6.
Fig. 3a
Cables supplied with autoloader (power cables not shown)