User manual

Olympus Series / Automated Standalone Asynchronous CD/DVD Duplication System / User Manual
21
Drive and Printer alignment
Turn on your system in the following order: tower, printer autoloader.
Click the Hyper Terminal icon on your Desktop
Press “Caps Lock” tab and then C once for the autoloader to do its short movement.
Open top drive manually, place discs in the input hopper and use the following
commands:
I = insert - autoloader will load the disc into the drive. If the disc was placed in the
right position, press
A = accept - to finish the alignment
Tight gently thumbscrews # 1 on both sides until they touch the adapter and then tight
thumbscrews # 2 (they consolidate the tower on the adapter – see Fig.9)
Fig. 9
Side View
In case you don’t have good alignment, adjust the tower (left and right, back and forth)
and repeat the steps above until you obtain the right alignment.
If your system is configured with a printer, open printer tray manually and repeat the above
steps using the printer.
Once printer alignment is OK, please tight, in the same time, front left and front right
thumbscrews # 3 (located on the printer plate – see Fig.5b – same for all printers).
Repeat this operation for rear left and rear right thumbscrews # 3.
When Drive and Printer alignment is complete, turn your system off.