User manual

HERA Series CD/DVD Duplication System / User Manual
25
Duplicator B.30
1. Copy (MM)
Duplicator B.30
3. Compare
Choose Partition
3-> [FUN ]CD
Counter:
No Counter
Preparing...
Please Wait
Loader Processing
Drive 1 <- Input Bin
Processing...
Please Wait
3. Compare
Use the Compare function to perform a bit-by-bit comparison between the content of your master disc(s)
in the Hard Drive and the contents of all discs it copied. This ensures that all of your copies are identical to
original master disc(s).
Note: The bit-by-bit comparison will only apply on all DVDs and Data CDs. The readability check will be
applied for other formats like Audio CDs, CD+G, and Video CD discs due to their lack of error correction
mechanisms.
If you are at the 1. Copy Menu, do the following:
Use the
Up or Down button to find the 3. Compare menu.
Press the
Enter button on 3. Compare menu to enter the
Choose Partition Menu and you will see a screen similar to the
following:
Use the
Up or Down button to find the partition where your master
disc is stored. Press the
Enter button to select that Partition. Next,
you will see the Counter Selection menu:
Follow the instructions shown in “Setting Counters” on page 18 to
continue. Once the counters have been set, press the
Enter button to
confirm. You will see the Preparing screen.
After a short interval, the robotic loader will pick the top disc from the input
spindle and place it into one of the drives. As this is happening, you will
see a screen similar to below:
This information screen shows what is happening. In this case, the
loader has taken a disc from the input spindle and is placing it into
Drive 1.
The loader will continue to remove discs from the input spindle and place those into drives until either all
of the drives are full, or the count that you loaded into the counter is reached.
It takes a few seconds for the autoloader to recognize all the discs.
The system will then compare the discs in the trays to the content of the master disc residing in the Hard
Drive partition you specified. When the comparison job is complete, the autoloader will place the good
discs and failed discs into corresponding areas and you will see a PASS/FAIL result screen similar to this:
Counter Specified No Counter Specified
PASS 16 FAIL 0
Job Completed! Press OK to
Finish
or:
Input Bin Empty (20)
Reset Hoppers?