User manual

HERA Series CD/DVD Duplication System / User Manual
12
2. Test (page 24)
Use the Test menu or Test quick key to simulate the copy process. With simulation, write once
recordable discs such as DVD-R, or CDR will be reusable. The purpose of simulation is to
ensure error free duplication.
Note: Due to physical limitations of the DVD+R recordable format, if you try to simulate DVD+R
copying, you will encounter failure messages.
Warning: If you are using CD/DVD Rewritable discs as your blank media during the simulation,
the content on those discs will be permanently erased.
3. Compare (page 25)
Use the Compare function to perform a bit-by-bit comparison between the content of your master
disc(s) in the Hard Drive and the contents of all discs it copied. This ensures that all of your
copies are identical to original master disc(s).
Note: The bit-by-bit comparison will only apply on all DVDs and Data CDs. The readability
check will be applied for other formats like Audio CDs, CD+G, and Video CDs discs due
to their lack of error correction mechanisms.
4. Test + Copy (page 26)
Use the Test + Copy menu option to simulate the copying process initially. Then, the autoloader
performs the actual copy process on the blank disc(s) that passed the simulation. For the blank
disc(s) that didn’t pass the simulation, the autoloader will place it/them to the Reject Area.
5. Copy + Compare (page 26)
Use the Copy + Compare menu option to make 100% reliable copies. After the copy process is
done, the autoloader automatically compares the copies from the content of your original master
disc.
6. Select Burn Speed (page 26)
Use the Select Burn Speed menu option or the Speed quick key to adjust the duplication speed
for the various blank disc formats. For additional information, see “Select Burn Speed” on page
21.
7. Select Source (page 28)
Use the Select Source menu or the Source quick key to tell the system where the content of the
master disc resides during duplication. At this point, Hard Drive is the only place where the