Operating Guide
ALL POWER™ WP300 WATER PUMP | 23
TROUBLESHOOTING GUIDE
The following troubleshooting guide is recommended for basic or common problems;
if there’s an issue with the generator that is not listed, please call 1-888-896-6881.
Problem Probable Cause Solution
Engine will not
start or starts
and runs rough.
1. Fuel valve OFF 1. Move fuel valve lever to ON
2. Choke OPEN 2. Move choke lever to CLOSED unless engine is warm.
3. Engine switch OFF. 3. Turn engine switch to ON.
4. Out of fuel. 4. Refuel.
5. Bad fuel; engine stored without treating or
draining gasoline, ore refueled with bad gasoline.
5. Drain fuel tank and carburetor. Refuel with fresh gasoline.
6. Spark plug faulty, fouled, or improperly gapped. 6. Remove and inspect spark plug. Clean, gap or replace spark plug.
7. Spark plug wet with fuel (ooded engine).
7. Remove and inspect spark plug. Dry and reinstall spark plug. Start
engine with throttle lever in FAST position.
8. Fuel lter clogged, carburetor malfunction,
ignition malfunction, valves stuck, etc.
8. Take engine to qualied mechanic. Replace or repair faulty
components as necessary.
Engine Lacks Power
1. Filter element(s) clogged. 1. Check air lter. Clean or replace lter.
2. Bad fuel; engine stored without treating or
draining gasoline, or refueled with bad gasoline.
2. Drain fuel tank and carburetor. Refuel with fresh gasoline.
3. Fuel lter clogged, carburetor malfunction,
ignition malfunction, valves stuck, etc.
3. Take engine to a qualied mechanic. Replace or repair faulty
components as necessary.
OWNER’S MANUAL | TROUBLESHOOTING 23