Replacement Part List

Operation (cont’d)

Powering 120 Volt AC Tools And Equipment:

1.Priortopoweringtoolsandequipment,makesurethegenerator’sratedvoltage,andamperage

capacity (120 V AC @ 66.7 AMPs) is adequate to supply all electrical loads that the unit will

power. If powering exceeds the generator’s capacity, it may be necessary to group one or more

of the tools and/or equipment for connection to a separate generator.

CAUTION: ATTEMPTING TO POWER SENSITIVE ELECTRONIC EQUIPMENT

WITHOUTTHEUSEOFANAPPROVEDLINECONDITIONERMAY CAUSE

DAMAGE TO THE EQUIPMENT. ALL-POWER IS NOT RESPONSIBLE FOR

ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE TO USE AN

APPROVED LINE CONDITIONER.

2. Once the generator is running, simply connect the power cords of 120 volt AC powered

tools and equipment into the 120 volt AC dual outlets.

NOTE: THE GENERATOR FEATURES AN AC NON-FUSE THERMAL PROTECTOR

TO PROTECT THE AC CIRCUIT IN CASE OF AN OVERLOAD. SHOULD

AN OVERLOAD OCCUR, THE BREAKER WILL POP.

3.Disconnectallelectricalpoweredtoolsandequipmentfromthegenerator’s120volt AC

duel outlets.

4. After the engine and generator have completely cooled, store generator in a safe, clean, dry

location(ifnotalreadyinstalled

10000W Generator