Operating instructions

TROUBLESHOOTING TIPS

WHEN THE SWITCH IS IN THE “I” POSITION THE MACHINE WILL NOT START

PROBABLE CAUSE SOLUTION

Electrical socket is faulty Check plug, socket, and fuses

Voltage is inadequate Check that the voltage is adequate

GFCI trips Reset / Try another outlet

Power cord is not plugged in Plug in power cord

THE PUMP DOES NOT REACH ADEQUATE PRESSURE OR FLUCTUATES

PROBABLE CAUSE

SOLUTION

Water Intake Filter is clogged Remove and clean filter

Pump is drawing air Tighten connections/bleed system

Suction valves are clogged/worn Clean or replace valves

Diameter of garden hose too small Replace with ¾ inch garden hose

Water supply is restricted Check hose for kinks or leaks

Insufficient water supply Fully open water source

THE PRESSURE WASHER HAS OR WILL NOT MAINTAIN PRESSURE

PROBABLE CAUSE

SOLUTION

Excessive air in waterline and pump Turn unit and water supply off /

Bleed system / Hold trigger down

THE PRESSURE WASHER MAKES EXCESSIVE NOISE

PROBABLE CAUSE SOLUTION

Intake is blocked Check the intake valves

Valves are worn, dirty, or clogged Check, clean or replace valves

Water Intake Filter is dirty Check, clean, or replace filter

THE MOTOR STOPS RUNNING WHILE IN USE

PROBABLE CAUSE SOLUTION

Net voltage lower than suggested Check that the voltage is adequate

1800 PSI Pressure Washer