Full Product Manual

3250W Generator

Operation (cont’d)

Powering 12 Volt DC tools and Equipment:

1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage

capacity (12VD

C) is adequate to supply all electrical loads that the unit will power. If powering

exceeds the generator’s capacity, it may be necessary to group one or more of the tools and/or

equi

pment for connection to a separate generator.

2. Connect the power cord of a 12 VDC powered tool or equi

pment to the DC Terminals.

CAUTION: MAKE SURE TO CONNECT THE POSITIVE (+) LEAD OF THE

POWER CORD TO THE POSITIVE (+) TERMINAL ON THE GENERATOR,

AND CONNECT THE NEGATIVE (-) LEAD OF THE POWER CORD TO THE

NEGATIVE (-) TERMINAL ON THE G

ENERATOR.

3. If using only a 12

V volt DC tool or equipment, turn the 120 volt AC If using only a 12V volt

DC tool or equi

pment, turn the 120 volt AC

4. Start and run the engine as des

cribed above

5. When finished using the generator, turn the engine power switch to its “OFF” position. Turn

the fuel valve to its “OFF” position.

6. Disconnect the electrical powered tools’ power cord from the generator’s DC term

inals.

7. After the engine and generator ha

ve completely cooled, store the generator in a safe, clean, dry

location (if not al

ready installed in one).