Operating instructions

AirCompressor

Compressor (cont'd)

Breaking Inthe Pump

1 Turn the pressure switch to the OFF position.

2 Open the petcock. Turn counterclockwise.

3 Plug in the power cord.

4 Turn the power switch to the ON position. The compressor will start.

Allow the compressor to run for 15 minutes, to break in the internal

parts.

CAUTION: AFTER ABOUT 15 MINUTES. IF THE UNIT DOES

NOT OPERATE PROPERLY, SHUT DOWN IMMEDIATELY,

AND CONTACT PRODUCT SERVICE.

5 After about 15 minutes, turn the power switch to the OFF position.

6 Close the petcock. Turn in the clockwise direction

7 Turn the power switch to the ON position. The compressor will start

and fill the tank to the kick-out pressure and stop.

Note: As compressed air is used, the pressure switch will restart

the motor automatically.

WARNING DO NOT START UNIT UNTIL YOU

HAVE ADDED OIL. You may use SAEIOW30

synthetic oil such as Mobil 1 which is API CG/CD

grade compliant.

OperatingInstructions

Daily Startup

1 Turn the power switch to the OFF position.

2 Close the tank petcock. Turn in the clockwise direction.

3 Plug in the power cord.

Note: During the initial break-in cycle, there will be a slight

electrical smell as the motor brushes seat. This is normal for

universal motors and will last for about 5 minutes.

PUMP OIL LEVEL

FILLWINDOW