Operating instructions

AirCom

Compressor(cont'd)

CompressorControls(cont'd)

• Regulated pressure gauge: This gauge measuresthe regulated

outlet pressure.

• Regulated pressure quick connect coupler: This couplerconnects

to the regulatedoutlet pressure.Toconnect air hose, pushcouplerin.

Todisconnectair hose, pullthe couplercollarback and separate the coupling.

ElectricalPowerRequirements

ElectricalWiring

Refer to the air compressor's serial label forthe unit'svoltageand

amperage requirements.

Use a dedicatedcircuit.For best performanceand reliable starting,the air

compressor mustbe pluggedinto a dedicated circuit,as closeas possible

to the fuseboxor circuitbreaker.The compressor will use the full capacityof

a typical 15 amp householdcircuit.If other devicesare on the same circuit,

the compressormay fail to start. Lowvoltage or an overloadedcircuitcan

result insluggishstartingthat causesthe motoroverload protectionsystem

circuitbreaker to trip, especiallyincold conditions.

Note: A circuitbreaker is recommended.If the air compressor is

connectedto a circuitprotected bya fuse, use dual element time

delay fuses (Buss Fusetrontype "1" only).

Note: Avoid use of extensioncords.If using an extensioncord

is necessary, be sure to use an extension with the correct

specifications.

For optimum performance, plug the compressor power cord directlyinto a

groundedwall socket.Do not use an extensioncord unless absolutely

necessary. Instead,use a longer air hoseto reach the area where the air is

needed.

If use of an extension cord cannotbe avoided, the cord should be no longer

than 100 feet and be a minimum wire size of 14 gauge (AWG).