Owner`s manual

Owner’s Manual
6
OPERATING INSTRUCTIONS
INITIAL BREAK-IN
1. Open to permit air to escape, so air pressure builds up in the air tank.
2. Plug power supply cord into correct power source.
3. Run the compressor in this no-load condition for 20 to 30
minutes to lubricate.
4. Close the air tank drain cock.
5. Y
our compressor is now ready for use.
• AFTER 2 WEEKS, TIGHTEN ALL NOTS AND BOLTS, INCLUDING HEAD BOLTS.
TANK REMOVAL/INSTALLATION
WARNING: Before removing or installing the portable air tank, be sure to disconnect air compressor unit
from power source.
REMOVING THE AIR T
ANK:
1. Turn the power switch off.
2. Lift the carry handle up and away from the portable tank.
3. Close the valve (1).
4. Disconnect the valve (2).
5. Loosen the rubber straps to release the air tank.
W
ARNING: Becarefull when releasing the straps they do have a tight fit.
The tank has now been properly disconnected from the air compressor unit. You can now move the tank freely
Installing the air tank:
1. T
urn the power switch off.
2. Place the portable air tank in the appropriate position. For correct position see picture below.
3. Fix the air tank to the compressor unit using the rubber straps.
4. Reconnect the valve. (2)
5. Open the valve. (1)
The portable air tank has been properly installed and connected to the air
compressor unit. Your air compressor is now ready for use.
Tank
Rubber Strap
Valve(2)
Handle
Switch
Valve(1)
Air Hose
Correct tank position
Incorrect tank position