User`s manual

10 - 5 10 - 5
MELSEC
10 ERROR CODE
Return value
(HEX)
Error definition Corrective action
8264
(2048
H)
Boot former ROM forwarding failure
8265
(2049
H)
Boot former transfer mode specification error
8266
(204A
H)
Not enough memory
8267
(204B
H)
Backup drive (former boot drive) ROM error
8268
(204C
H)
Block size error
8269
(204D
H)
RUN-time detaching error
8270
(204E
H)
Module has already registered
8271
(204F
H)
Password registration data full error
8272
(2050
H)
Password unregistration error
8273
(2051
H)
Remote password error
8274
(2052
H)
IP address error
8275
(2053
H)
Error (argument when requesting) outside time-out value range
8276
(2054
H)
Instruction cast undetection
8277
(2055
H)
Trace execution type error
8278
(2056
H)
Version error
Exit the program and restart the PC.
Setup the package again.
Consult with the dealer regarding the problem.
16384 to 20479
(4000
H to 4FFFH)
Errors detected by the access target CPU.
Refer to the user's manual of the access target
CPU module.
16386
(4002
H)
A request that cannot be processed was received. Change the request destination.
16432
(4030
H)
The specified device type does not exist. Check the specified device type.
16433
(4031
H)
The specified device number is out of range Check the specified device number.
16448
(4040
H)
The module does not exist.
Do not issue a request that generated an error to
the specified special module.
16449
(4041
H)
The number of device points is out of range.
Check the head address and number of access
points and access within the existing range.
16450
(4042
H)
Corresponding module error
Check if the specified module is operating
normally
16451
(4043
H)
The module does not exist at the specified location.
Check the head I/O number of the specified
module.
28672 to 32767
(7000
H to 7FFFH)
Errors detected by intelligent function modules such as the serial
communication module.
Refer to the user’s manual of the access target
intelligent function module.
40577
(9E81
H)
Device type error
The device type specified for the destination station is invalid.
(It is checked by the destination link module).
Check the device type.
40578
(9E82
H)
Device number error
The device number specified for the destination station is out of
range.
When specifying the bit device, the device number is not a
multiple of 8.
(It is checked by the destination link module).
Check the device number.
40579
(9E83
H)
Devices points error
The number of points specified for the destination station is out of
range.
When specifying the bit device, the device number is not a
multiple of 8.
(It is checked by the destination link module).
Check the size.