User`s manual

6 - 6 6 - 6
MELSEC
6 INSTALLING AND UNINSTALLING THE SOFTWARE PACKAGE
6.1.2 Installing the utility
The following explains the installation procedure of the utility.
The screens of Windows
R
2000 Professional are used in the explanation.
Therefore, these screens are slightly different from other operating systems.
Install the utilities with reference to REMARK
.
POINT
(1) When using the following Operating systems, logon as a user who has
administrator authority.
• Windows
R
XP Professional
• Windows
R
2000 Professional
• Windows NT
R
Workstation 4.0
(2) Disassociate all applications registered in the startup procedure, then execute
installation after restarting Windows
R
.
(3) Make sure to close other applications running on Windows
R
(including resident
software such as antivirus software) before installation.
(4) Be sure to uninstall SWnDNF-CCLINK first, then install SW4DNF-CCLINK-B.
Since all the data set by each utility will be erased, it is necessary to set them
again.
(5) To install the utility, use "Add/Remove Programs" in "Control Panel."
As an alternative method, you can execute "Setup.exe".
Double-click "Setup.exe" in Disk 1, then start the installation from item [6.]
below.
1. Power on the PC and start Windows
R
.
2. Open [Start] - [Settings] - [Control Panel].
REMARK
When Windows
R
XP Professional is used, open [Start] - [Control
Panel].
3. Open "Add/Remove Programs" and select "Add New Program."
When the screen shown at the left is displayed, click the
CD or Floppy
button.
REMARK
When Windows
R
95, Windows
R
98, or Windows NT
R
Workstation 4.0
is used, open "Add/Remove Programs" and click the Install...
button.
(To the next page)