User`s manual

11 - 18 11 - 18
MELSEC
11 TROUBLESHOOTING
(From the previous page)
3) Execute WDTSETNE.exe.
Enter "A:\Tools\WDTSETNT.exe", and then press the Enter
key.
REMARK
Above enter example is relevant to Windows NT
R
Workstation 4.0
and Windows
R
2000 Professional or Windows
R
XP Professional.
When Windows
R
95 or Windows
R
98 is used, enter
"A:\Tools\WDTSET95.exe", and then press the Enter
key.
4) As the message shown left is displayed, enter in "WDT Setting
Value" the value large enough to avoid WDT error, and then press
the Enter
key. (Setting range: 1 to 32767)
WDT time is defined by the value set to "WDT Setting Value" as
shown below.
(WDT time) = (Value set as "WDT Setting Value") × 8ms.
"WDT Setting Value" is factory-set to "300".
If "WDT Setting Value" is set to "0" and the Enter
key is pressed,
the currently set value will be displayed.
5) When "done" is displayed after the above setting, this means the
setting operation is completed. End the command prompt and
restart the personal computer.
REMARK
If "ERROR" is displayed, reinstall the software package or operating
system.
(Complete)
POINT
If WDT error still occurs after the above operations reset "WDT Setting Value".
(Enter the value larger than previous setting.)