User`s guide

Pin 1

Pin 2

Pin 1

Pin 2

www.ti.com

Connecting the CC Debugger to the Device

6 Connecting the CC Debugger to the Device

6.1 Target Connector Details

The target connector, located on the lateral side of the debugger, is a 10-pin 2x5 2.54 mm pitch connector

with a direction coded plastic guide. Suggested matching (male) surface mounted headers would be

95278-101A10LF from FCI or BB02-HP from GradConn.

Figure 2. Placement of Target Connector Pins

The adapter board, which has a 10-pin 2x5 1.27 mm pitch connector, has the same pin placement.

Suggested matching (male) surface mounted headers would be 20021121-000-10C4LF from FCI or FTS-

105-01-F-DV from Samtec.

Figure 3. Placement of Target Connector Pins on Adapter Board

The pin-out of the target connector is shown in Figure 4. Note that not all of these pins need to be

connected to the target device for programming and debugging. Only VDD, GND, DD, DC and RESET are

required for the SoC. The other pins are optional or for special features.

SWRU197H–September 2010–Revised April 2014 CC Debugger

Submit Documentation Feedback