User`s guide
www.ti.com
Abbreviations and Acronyms
2 Abbreviations and Acronyms
CSn Chip Select (active low)
DC Debug Clock
DD Debug Data
DUT Device Under Test
GND Ground
LED Light Emitting Diode
MISO Master In Slave Out
MOSI Master Out Slave In
RF Radio Frequency
SCLK Serial Clock
SoC System-on-Chip
SPI Serial Peripheral Interface
USB Universal Serial Bus
V
DD
Positive voltage on target
3 Box Contents
• 1 x CC Debugger
• 1 x USB-A to Mini-B USB cable
• 1 x 10-pin flat cable with 2x5 2.54 mm connector
• 1 x 10-pin flat cable with 2x5 1.27 mm connector
• 1 x Converter board 2.54 mm – 1.27 mm connector
• Documentation
4 Operating Conditions of the CC Debugger
Minimum target voltage: 1.2 V
Maximum target voltage: 3.6 V
Operating temperature: 0°C to 85°C
Regulated voltage on CC Debugger: 3.3 V
Maximum target current:
(1)
200 mA
(1)
Microsoft
®
Windows
®
2000 operating
Supported Operating Systems:
system
Windows XP SP2/SP3 operating system (32-bit versions)
Windows Vista
®
operating system (32 and 64 bit)
Windows 7 operating system (32 and 64 bit)
Windows 8 operating system (32 and 64 bit)
(1)
Only applicable if the target is powered from the CC Debugger.
5
SWRU197H–September 2010–Revised April 2014 CC Debugger
Submit Documentation Feedback
Copyright © 2010–2014, Texas Instruments Incorporated