User`s guide

www.ti.com

List of Figures

1 Verify Correct Driver Installation ........................................................................................... 6

2 Placement of Target Connector Pins...................................................................................... 7

3 Placement of Target Connector Pins on Adapter Board ............................................................... 7

4 Target Connector Pin-Out .................................................................................................. 8

5 Voltage From Target to CC Debugger .................................................................................... 8

6 Minimum Connection for Debugging of 8051 SoC ...................................................................... 9

7 Connection to SoC to Enable Packet Sniffing.......................................................................... 10

8 CC Debugger Connected to CC2520.................................................................................... 11

9 CC Debugger Connected to CC112x/CC1175/CC120x............................................................... 12

10 CC Debugger Connected to CC110x/CC11xL/CC2500............................................................... 12

11 CC Debugger Connected to CC85XX ................................................................................... 12

12 Auto Firmware Upgrade ................................................................................................... 14

13 Auto Firmware Update..................................................................................................... 15

14 Firmware Successfully Updated.......................................................................................... 15

15 SmartRF Flash Programmer - Manually Updating the Bootloader .................................................. 16

16 Internal View of CC Debugger............................................................................................ 17

17 Short-Circuit Pins for Boot Recovery Mode............................................................................. 17

18 Programming the Bootloader on the CC Debugger Using Another CC Debugger ................................ 18

19 Programming the Bootloader on the CC Debugger Using SmartRF05EB.......................................... 18

20 SmartRF Flash Programmer - Updating the Bootloader .............................................................. 19

List of Tables

1 Supported SPI Connections (marked OK) .............................................................................. 10

2 USART Pin Out Details.................................................................................................... 10

3 Understanding the LED.................................................................................................... 13

4 Troubleshooting FAQs..................................................................................................... 21

SWRU197H–September 2010–Revised April 2014 List of Figures

Submit Documentation Feedback