User`s guide

Contents

1 Introduction......................................................................................................................... 4

2 Abbreviations and Acronyms ................................................................................................ 5

3 Box Contents....................................................................................................................... 5

4 Operating Conditions of the CC Debugger .............................................................................. 5

5 Initial Steps ......................................................................................................................... 6

5.1 Installing the USB Driver ................................................................................................ 6

5.2 Supported PC Tools ..................................................................................................... 6

6 Connecting the CC Debugger to the Device ............................................................................ 7

6.1 Target Connector Details................................................................................................ 7

6.2 Connecting the CC Debugger to a System-on-Chip................................................................. 8

6.3 Connecting the CC Debugger to a Transceiver .................................................................... 11

6.4 Connecting the CC Debugger to a CC85xx......................................................................... 12

7 Using the CC Debugger....................................................................................................... 13

7.1 Understanding the LED ................................................................................................ 13

8 Updating the Firmware........................................................................................................ 14

8.1 Updating the Firmware Automatically in SmartRF Studio ......................................................... 14

8.2 Updating the Firmware Manually in SmartRF Flash Programmer ............................................... 16

8.3 Forced Boot Recovery Mode.......................................................................................... 17

8.4 Resurrecting the CC Debugger ....................................................................................... 17

9 Troubleshooting................................................................................................................. 21

10 Schematics........................................................................................................................ 22

11 References ........................................................................................................................ 22

Appendix A Schematic................................................................................................................ 23

Revision History.......................................................................................................................... 24

Table of Contents SWRU197H–September 2010–Revised April 2014

Submit Documentation Feedback