User`s guide
1
1
2
4
5
3
Updating the Firmware
www.ti.com
8.2 Updating the Firmware Manually in SmartRF Flash Programmer
You can also update the firmware manually using the SmartRF Flash Programmer (illustrated in
Figure 15). You can use this method if you like to have full control of the firmware image to be
programmed on the controller of the debugger (for example, programming custom firmware or old
firmware revisions).
1. Start the SmartRF Flash Programmer and select the EB application (USB) tab. This tab lets you
program compatible firmware on the CC Debugger (or evaluation boards) via the USB interface (no
external programming device required).
2. Disconnect the debugger from any target board and connect it to the PC via the USB cable. The
debugger appears in the list of connected devices. The chip type is listed as N/A.
3. Select the Flash image you want to program on the debugger. Normally, you would select: C:\Program
Files (x86)\Texas Instruments\SmartRF Tools\Firmware\CC Debugger\cebal_fw_srf05dbg.hex.
(1)
4. Select Erase, program and verify in the Actions box.
5. Click the Perform actions button. The programming procedure will start. Note that this takes several
seconds.
6. The CC Debugger reappears in the list of connected devices, now showing the new firmware revision
in the device list.
7. Done!
Figure 15. SmartRF Flash Programmer - Manually Updating the Bootloader
(1)
Assuming default installation path of SmartRF Flash Programmer.
16
CC Debugger SWRU197H–September 2010–Revised April 2014
Submit Documentation Feedback
Copyright © 2010–2014, Texas Instruments Incorporated