Technical data

42 • Fieldbus coupler/controller
Fieldbus coupler 750-310
WAGO-I/O-SYSTEM 750
CC-Link
3.1.2.5 Configuration Interface
The configuration interface used for the communication with
WAGO-I/O-CHECK or for firmware transfer is located behind the cover flap.
Configuration
interface
open
flap
Fig. 3-5: Configuration interface g01xx06e
Attention
Only the communication cable (750-920) may be connected to the 4 pole
header.
3.1.2.6 Station Address
Two selector switches are used to set the address of the CC-Link-coupler.
Fig. 3-6:Station address selector switch g013902x
The switch ‚x1‘ determines the units position of the address, the switch ‚x10‘
determines the decimal positions of the address (for example ‚x1‘ = 2,
‚x10‘ = 3, address = 10 * 3 + 2 = 32)
A valid CC-Link station address can be set within the range from 1 to 64.
The configuration is only read during the power up sequence. Changing the
switch position during operation does not change the configuration of the
buscoupler. Turn off and on the power supply for the fieldbus coupler to ac-
cept the changing.