Technical data

The WAGO-I/O-SYSTEM 750 • 11
Storage, Consignment and Transport
WAGO-I/O-SYSTEM 750
CC-Link
2.4 Storage, Consignment and Transport
Wherever possible, the components are to be stored in their original packag-
ing. Likewise, the original packaging provides optimal protection during
transport.
When consigning or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in appro-
priate containers/packaging. Thereby, the ESD information is to be regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and sili-
cone has been ruled out, e.g. 3M 1900E.
2.5 Mechanical Setup
2.5.1 Installation Position
Along with horizontal and vertical installation, all other installation positions
are allowed.
Attention
In the case of vertical assembly, an end stop has to be mounted as an addi-
tional safeguard against slipping.
WAGO item 249-117/002-000 End stop for DIN 35 rail, 10 mm wide
2.5.2 Total Expansion
The maximum total expansion of a node is calculated as follows:
Quantity Width Components
1 51 mm coupler / controller
64 12 mm bus modules
- inputs / outputs
- power supply modules
- etc.
1 12 mm end stop
sum 831 mm
Warning
The maximal total expansion of a node must not exceed 831 mm