Instruction manual

Installation Overview
2 CC/CCS Power Conditioner User Manual
violation of electrical code.
WARNUNG : Dieses
Leistungsanpassungsgerät führt
lebensgefährliche Spannung.
Stromschlaggefahr! Bitte beachten Sie die in
Ihrem Land geltenden Vorschriften über die
Verdrahtung und Beschaltung.
What Equipment
Needs Power
Conditioning?
Only your electronic based equipment requires
conditioned power. Fans, air conditioners and
motors do not require power conditioning.
Placing fans, air conditioners, motors or other
noise generators between the conditioner and
the electronics introduces electrical interference
into the already conditioned power. In order to
minimize electrical noise, each piece of
equipment should be individually wired back to
the output of the ONEAC power conditioner.
Sizing Information The rating label of your ONEAC power
conditioner lists the model’s current rating,
nominal input and output voltage and serial
number. The combined steady state RMS
current draw of all your equipment must not
exceed the power conditioner’s output current
rating.
Installation
Overview
NOTE: Only qualified electricians should
install an ONEAC power conditioner. Follow
the U.S. National Electrical Code
®
, local codes,
good wiring practice and this User Manual.
1. Unpack the power conditioner (see
Unpacking and Placement on page 5).
2. Move the POWER CONDITIONER to the
installation location.
3. Connect the input plug or conduit. On
hardwire models, use a equipment
grounding conductor that is equal or larger
than the current carrying conductors (see
Input Connections on page 6).
4. Turn on the power feed to the input.