Instruction manual

Troubleshooting an Installation
26 CC/CCS Power Conditioner User Manual
Fig. 9: CCS Terminal Block Secondary
Configurations
NOTE: For the CCS Series 240 V or 240/120 V
Split Phase Secondary Terminal Block
Configuration, Neutral-Ground bonding is
completed at the capacitor connections of either
the RED (240 V grounded) or the WHITE (240/
120 V Split phase) wire.
NOTE: To operate the CCS Series power
conditioner at 208 V input with 208 V output,
use the same tap selection as 240 V input and
240 V output.
Troubleshootin
g an Installation
If there is power at the input with no power at
the output, turn OFF the circuit breaker and then
the input power to the conditioner - the main
power source or service disconnect.
Check the values specified on the nameplate.
Verify that your main power source is correct
for the power conditioners input voltage.
Verify that the power conditioner’s input
voltage has not been changed in the field.
If everything seems correct, disconnect the line
and ground input wires and then contact
Technical Services. Refer to
Technical Support
CCS Series: 240 V or 240/120 V
Split Phase Secondary
CCS Series: 120 V Secondary