Instruction manual
Installation and Operation
12 CC/CCS Power Conditioner User Manual
connection to ground. ONEAC
discourages the down sizing of grounding
conductors as allowed by various codes. If
in doubt regarding wire size, consult the
U.S. National Electrical Code, Table
310-16, or your local Electrical Codes.
10. Connect the output phase wires to the
output terminal block. Separate the input
power cable to the ONEAC power
conditioner from the equipment power
cable. Data cables should be kept as far
away from any power cables as possible.
11. Torque all connections. Refer to the torque
specifications in
Maintenance on page 19.
Replace the rear terminal box cover or
conduit landing plate and unit cover.
12. Turn ON the ONEAC power conditioner
and then your equipment.
13. Begin normal operation of your
equipment.
Output fuses
Output fuses are located above the conditioner’s
receptacles or hardwire terminal connections.
Refer to
Fuse Replacement on page 21 for
details on fuse replacement.
Use of the Environmental