User`s guide

PC*MILER-AS400 User’s Guide 11

3.2 AS400 Side Installation

First install the resident AS400 software on your AS400. Sign on to

QSECOFR or an account with equivalent authorities. Place the CD in the

optical drive and follow the instructions below.

NOTES For Upgrades: If you are upgrading your ALKWIN or ALKTLL

Library from an earlier version, it is recommended that you rename your

current ALKWIN [or ALKTLL] Library or clear your current library with the

CLRLIB command.

Before clearing your current library, type ‘config’ or ‘tllfig’ from the AS400

command line and write down your current default settings. These

settings will be overwritten during the library restore. After the restore of

the library, re-enter these settings by running the ALKWIN/CONFIG

command.

For Version 16 and Higher: ALK increased the length of the Highway

Segment (HS – Turn-by-Turn Driving Instructions) by 25 characters.

Failure to upgrade your current ALKWIN Library from pre-Version 16 will

cause the program to crash if HS requests are used.

1. Create a library with the CRTLIB command. Type CRTLIB ALKWIN

[or ALKTLL].

2. Add the library to the current library list. Type ADDLIBLE ALKWIN [or

ALKTLL].

(Statements in the following paragraph do not apply for installations

that include PC*MILER|Tolls.)

For Innovative Computing Corporation installations, you will also need

your ICC WORK and FILE libraries in your current library list. For

Version R6, type ADDLIBLE I93FILE or ITSR6FILE and then

ADDLIBLE I93WORK or ITSR6WORK. The ICC Version 7 libraries

are IESR7WORK and IESR7FILE. (Call ICC if you don’t know which

version you are running.)

3. Command for restoring from CD:

rstlib savlib(alkwin) dev(opt01) vol(alkwin) Label(alkwin)

mbropt(*all) alwobjdif(*all) rstlib(alkwin)

rstlib savlib(alktll) dev(opt01) vol(alktll) Label(alktll)

mbropt(*all) alwobjdif(*all) rstlib(alktll)

where opt01 is your CD-ROM drive.