Installation manual

10/3/2012 601-900-3224-INST
3
cable; do not force the board from the case. There are four (4) switches on the circuit board; the
switches allow the user to select the features desired. The settings are listed below. When reinstalling
the face on the Co-Pilot do not over tighten the 2 small screws on the face or faceplate damage will
result.
Dip switch selection:
---------------------------------------------------------------------------------------------------------------------------------------
Switch #1
Flip #1 switch to OFF position
---------------------------------------------------------------------------------------------------------------------------------------
Switch #2
Automatically cancels OD from a stop, only cancels once after ignition has cycled, cancels at
speed above 3mph.
If you want automatic OD cancel from a stop flip #2 switch ON
If you do not want automatic OD cancel from a stop and you did not hook up the white wire,
flip #2 switch ON
If you do not want automatic OD cancel from a stop and you did hook up the white wire, flip
#2 switch OFF
----------------------------------------------------------------------------------------------------------------------------------------
Switch #3
Speed setting
On=low speed cut out (deceleration only) This setting is designed to be used with an exhaust brake.
Off=Hi speed cut out (deceleration only)This is recommended.
----------------------------------------------------------------------------------------------------------------------------------------
Switch #4
Flip #4 switch to OFF position
---------------------------------------------------------------------------------------------------------------------------------------
We have preset your module with switch #1-OFF, #2-ON, #3-OFF, #4-OFF