Instruction manual

76
Capture the picture (.JPG)
Snapshot time offset: (ms)
The function is the time setting of previous/post snapshot. The valid range is from -10000 to
10000
Snapshot interval time: (ms)
The function is the time setting of interval snapshot. The valid range is from 0 to 1000000
Snapshot frames: (frames)
The function is the frames setting of snapshot. The valid range is from 1 to 999
NOTE：
The “ms” mean the -100 second. If the setting would be set the 60000ms, the result is the 1 min.
For example, the “Snapshot time offset” parameter was used the “-“. The ”-” parameter means
previous capture the image.
Type Capture
FTP
1 Picture
Snapshot Interval Time(-)
1 Picture
- - - - Snapshot Frames
Mail
1 Picture
Snapshot Interval Time(-)
1 Picture
- - - - Snapshot Frames
Samba
1 Picture
Snapshot Interval Time(-)
1 Picture
- - - - Snapshot Frames
SD Card
1 Picture
Snapshot Interval Time(-)
1 Picture
- - - - Snapshot Frames
Hard Disk
1 Picture
Snapshot Interval Time(-)
1 Picture
- - - - Snapshot Frames
When the event was triggered, the IP Camera will continue to capture the pictures. The total frames
will follow all setting to send the picture.
e.g. The continue motion result
Event Setting: Trigger by = Motion / Type: .jpg / Upload video to: FTP
Include Snapshot time offset: -1000 ms / Include Snapshot interval time: 1000 ms / Snapshot frames: 5
01 (1 Sec) 02 (1 Sec) 03 (1 Sec) 04 (1 Sec) 05
Ca
p
ture Start
Trigger Start
-Snapshot Time Offset-
Ca
p
ture Start
Trigger Start