Instruction manual

75
Record the image (.AVI)
Include pre-trigger buffer:
When an event is detected, the camera will record the previous video image up to 10 seconds.
Include post-trigger buffer:
When an event is detected, the camera will record the post video image up to 10 seconds.
Continue video upload:
When the event is continue, the camera will record the video image up to 10 seconds.
NOTE：
Every default time setting is the 5 second.
Type
Pre Record Continue Record Post Record
FTP
1~10 Second 1~10 Second 1~10 Second
Mail
1~10 Second 1~10 Second 1~10 Second
Samba
1~10 Second 1~10 Second 1~10 Second
SD Card
1~10 Second 1~10 Second 1~10 Second
Hard Disk
1~10 Second 1~10 Second 1~10 Second
When the event was triggered, the IP Camera will record the image. The IP Camera will auto
record the previous image before trigger start and the post image after trigger end. According the
distinct service, the previous/post recording time will be a little difference.
The continue record will keep to detect the event then record the image from the Trigger Start to the
Trigger End.
The total recording time are Pre + Continue + Post recording time.
e.g. The continue motion result
Event Setting: Trigger by = Motion / Type: .avi / Upload video to: FTP
Include pre-trigger buffer: 5 sec / Include post-trigger buffer: 5 sec / Continue video upload: 10 sec
Motion 1
01 20 sec
Motion 2
15 35 sec
Motion 3
30 50 sec
Record Start
Record End
Trigger Start Trigger End