Instruction manual

12
Hardware Installation
You can install the product on your desk or use the attached tripod to hang it from the wall or ceiling.
(The product is provided with image flip function. Refer to the “Control Panel” for more information.)
1. Connect to the Video In
Plug one end of the video source of your analog camera and connect the other end to your product.
Connect one ~ four channels to ALS-7721 according to the requirement.
NOTE：
If the analog camera can be provided the Pan/Tilt/Zoom control, plug one end of your control cable in the RS-485
socket on the back of the camera and connect the other end to your product.
2. Connect to the power source for analog camera
Plug one end of the attached power cable in the power socket of your camera and connect the
other end to the AC power source.
NOTE：
Make sure your analog camera uses BNC connectors for the video in/out. If not, please consult your dealer or retailer to
purchase or buy the adapter to use.