User`s manual

System setting
System setting contains basic and application settings. The basic setting is executed
for basic system information, transmission speed, audio/video code, user authorization,
date/time, and IP filter, while the application setting is executed for event triggering
definition and other relevant settings, definition of the motion detection area,
firmware update, reset to factory default, and reboot of the machine.
Basic Setting
Click Setting to enter
the setting page
Basic Setting > System (System info)
 Basic Setting > System > System Info
Device Name: You can set the name for your camera here. Click Set to complete
the setting.
MAC Address, IP Address, Network Mask, Gateway: Network information.
Firmware: Firmware version information.
Current Viewers: The number of viewers who are currently accessing the video
stream.
LED: Event status: You can set the LED display mode (ON, OFF, Flash) here.
ON: The LED flashes when any motion detection or alert trigger is
identified.
OFF: LED is turned off.
Flash: LED flashes according to the user-defined interval.
LED: Link status: You can set the LED display mode (ON, OFF, Flash) here
ON: The LED lights up green when a video stream is detected.
Otherwise, it does not activated.
OFF: LED is turned off.
Flash: LED flashes according t o the user-defined interval.
 Basic Setting > System > System Log
The administrator can view all login information of this camera, including boot
record, video streaming mode, login IP, changes, and the date/time information.
You can copy the entries to a Word document and save them manually. Please
note that all information are deleted when you turn off the machine.
27