User manual
Table Of Contents
- Contents
- Package Contents
- Camera Unit Pack
- Accessory Pack
- Introduction
- Features and advantages
- System Introduction
- Hardware Installation
- Camera Setting from a Router
- Enter the Main Page
- Camera Main Page
- Basic Settings
- Basic Setting > System (System info)
- Basic Setting >Video/Image
- Basic Setting > Audio (Sound)
- Basic Setting > User(User)
- Basic Setting > Network (Network Settings)
- Basic Setting > Network > Network (cable network setting page)
- Basic Setting > Network > Streaming (streaming Setting)
- Basic Setting > Network > PPPoE (dial-up networking setting)
- Basic Setting > Network > DDNS (Dynamic Domain Name Server Setting)
- Basic Setting > Network > UPnP (Universal Plug and Play)
- Basic Setting > Network > SMTP Server (mail server setting)
- Basic Setting > Network > Samba
- Basic Setting >\ Network >\ Multicast
- Basic Setting > Date/Time (date/time setting)
- Basic Setting > IP Filter
- Application Setting > Event (event trigger setting page)
- Application Setting > Firmware upgrade
- Application Setting > Factory Default
- Application Setting > Reboot
- Attachment A: External Alarm
- Attachment C: Troubleshooting and FAQs
- FCC Class B Announcement
External Alarm I/O Circuit Diagram
Warning! The alarm will be
triggered when alarm pin 4 & 5
are formed as a short circuit.
Please do not connect the electric
voltage or current into alarm input
p
in because the electronic current
Pin 5
Pin 4
Warning! The alarm will be
triggered when alarm pin 4 & 6
are formed as a short circuit.
Please do not connect the electric
voltage or current into alarm input
pin because the electronic current
Pin 6
Warning!
‧Where connecting of a low or high current loop to the external alarm input/output of
the product is required, the wiring and connection shall be conducted by a qualified
electrician. Incorrect wiring may bring about damage to the product fatal electric
shock.
‧Direct connection of the external alarm input/output terminal to high-current
equipment is not allowed and a customized repeat circuit might be required (provided
by the customer) for some cases to isolate the terminal and the high-current
equipment. Where the voltage/current of an external device exceeds the loading
capability (5V) of the Alarm I/O, the product would be damaged seriously.
87