User manual
Table Of Contents
- Contents
- Package Contents
- Camera Unit Pack
- Accessory Pack
- Introduction
- Features and advantages
- System Introduction
- Hardware Installation
- Camera Setting from a Router
- Enter the Main Page
- Camera Main Page
- Basic Settings
- Basic Setting > System (System info)
- Basic Setting >Video/Image
- Basic Setting > Audio (Sound)
- Basic Setting > User(User)
- Basic Setting > Network (Network Settings)
- Basic Setting > Network > Network (cable network setting page)
- Basic Setting > Network > Streaming (streaming Setting)
- Basic Setting > Network > PPPoE (dial-up networking setting)
- Basic Setting > Network > DDNS (Dynamic Domain Name Server Setting)
- Basic Setting > Network > UPnP (Universal Plug and Play)
- Basic Setting > Network > SMTP Server (mail server setting)
- Basic Setting > Network > Samba
- Basic Setting >\ Network >\ Multicast
- Basic Setting > Date/Time (date/time setting)
- Basic Setting > IP Filter
- Application Setting > Event (event trigger setting page)
- Application Setting > Firmware upgrade
- Application Setting > Factory Default
- Application Setting > Reboot
- Attachment A: External Alarm
- Attachment C: Troubleshooting and FAQs
- FCC Class B Announcement
2. Click Exceptions
1. Click Windows Firewall in the Control Panel
3. Check UPnP Configuration.
3. View the connection device using “My Network Place”
1. Open “My Network Place”
2. The LAN camera appears.
Double-click to access the main page.
Basic Setting > Network > SMTP Server (mail server setting)
This camera is able to transmit images to a particular email address when a motion
detection event occurs or a sensor is triggered. To use this function, a mail server
setting for the camera is required.
Enter the following information in sequential order to complete the setting:
z SMTP server: the SMTP server IP address.
z SMTP From: the email of the sender, i.e. xxx@xxx.com
z SMTP Authentication: enables/disables
62